The content in this guide was originally created by Leon @SpikerEng on TacomaWorld as a series of posts over several months. I've captured it here for two reasons: I want to make sure that, should anything happen to Leon's post, that we all still have access to this amazingly useful…
7 CommentsGuide Section: Suspension
Leaf springs, coilovers, bump stops, relocation of rear shocks, and the largest tire you can fit on a lifted Tacoma.
I recently relocated the rear shock mounts on my 2000 Toyota Tacoma, and it didn't go so well...at least the first time. I didn't get the mounts in quite the right position (you can read the whole story here) and that meant cutting them off and doing everything a second…
Leave a Comment
I've discussed the trade-offs between disposable and rebuildable shocks in the past as I've replaced spherical bearings in my ADS coilovers, but I've never walked through the process of actually rebuilding the internals of a smooth body shock before. But, now that my shocks have absorbed some ~80K miles, it's…
Leave a Comment
I've discussed the trade-offs between disposable and rebuildable shocks in the past as I've replaced spherical bearings in my ADS coilovers, but I've never walked through the process of actually rebuilding the internals of a smooth body shock before. But, now that my shocks have absorbed some ~50K miles, it's…
2 Comments
Sooner or later, every Tacoma will need to have its leaf springs replaced. Most commonly, replacement is considered only when one of the installed leafs breaks, or when the rear end of the truck seems to sag under light - or even non-existent - loads. With a few tricks to…
12 Comments
I recently installed SPC Performance upper control arms (25460) on my 2000 Tacoma, and it went great. In addition to the story of the install, I figured a detailed set of instructions for anyone wanting to tackle this themselves would be nice to put together, since it's hard to find that…
14 Comments
Over time, rubber bushings wear out and need to be replaced. This happened for me recently when I Replaced All the Bushings on my Tacoma, and I figured that others could benefit from a quick little guide that shows the entire process and lists all the necessary parts. Before getting started,…
38 Comments
Over the last couple years, I've learned - mostly from others experience - that it's a good idea to keep an eye on 1st gen Tacoma lower ball joints (LBJs). If you do lots of bumpy, off-road style driving, every 30-50,000 miles is a reasonable interval to change this part…
Leave a Comment
This question is asked often enough that I figured it was finally time to put together an answer that gives lots of information, but that doesn't have to be re-typed again and again. Because that will save everyone a bunch of time, hopefully! So, let's start with the basic question…
20 Comments